35
139587_05 GF 200 DV IPI October 2015
WARNING:
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
A.
This appliance is equipped with an ignition device
which automatically lights the pilot.
Do Not
try to light
the pilot by hand.
B. BEFORE LIGHTING,
smell all around the appliance
area for gas.
Be sure to smell next to the floor because some gas
is heavier than air and will settle to the floor.
WHAT TO DO IF YOU SMELL GAS:
• Extinguish any open flame
• Open windows.
• Do not light this or any other appliance.
• Do not touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone.
• If your gas supplier cannot be reached, call the
fire department.
C.
Use only your hand to turn the gas control knob.
Never use tools. If the knob will not turn by hand, do
not try to force it or repair it.
Call a qualified technician. Force or attempted
repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been
under water. Immediately call a qualified ser
-
vice technician to inspect the appliance and to
replace any part of the control system and any
gas control which has been under water.
LIGHTING INSTRUCTIONS
FOR YOUR SAFETY, READ BEFORE LIGHTING
.
1.
Set the thermostat to the lowest setting.
2
. Turn off all electric power to the appliance if
service is to be performed.
3.
Set the Burner switch to the “OFF” position.
4.
Close control access door.
TO TURN OFF GAS TO THE APPLIANCE
1.
STOP! Read the safety information above.
2.
Set the thermostat, if equipped, to the lowest
setting.
3.
Set the Burner switch to the “OFF” position.
4.
This appliance is equipped with an ignition
device which automatically lights the pilot.
Do not try to light the pilot by hand.
5.
Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor.
If you smell gas, STOP! Follow “B” in the safety
information above on this label. If you do not
smell gas, go to the next step.
6.
Set the Pilot Mode switch to CPI for continuous
operation. The pilot will light. Set Pilot to IPI for
intermitent operation. The pilot will light when
there is a call for heat.
7.
Set the Burner switch to the “ON” or “T-STAT”
position.
8.
Set the thermostat to the desired setting to
light the burner. If the appliance will not oper-
ate,
follow the instructions ”To Turn Off Gas To
Appliance”, and call your service technician or
gas supplier.
OPERATING INSTRUCTIONS
Pilot
Controls
PILOT ASSEMBLY
Burner
Controls