1. Slide P/S seat completely back. Use T30 torx
bit to loosen (2) upper seat bolts on top of pedestal
inside seat rails. (PicA)
2. Press on seat back to tilt backwards, slide base
underneath seat rails and pedestal.
3. Use 18mm socket to remove (1) inner lower
seat bolt on floor of pedestal. (Pic B)
4. Rotate vertical arm so that floor bracket is over
lower seat bolt hole.
5. Hand thread lower seat bolt through floor bracket, into floor of vehicle. Do
not tighten.
6. Use T30 torx bit to tighten (2) upper seat bolts from Step 1.
7. Use 7/16 hex socket to tighten (2) vertical arm bolts.
8. Use 18mm socket to tighten (1) lower seat bolt on floor of pedestal. (Pic C)
9. Assemble the desktop stand to the mount base, starting with the vertical
tube. Use 2 hex head cap screws and 2 lock washers to secure vertical
tube to mount post.
10. Place articulated swing arm over the 5/8” end of the telescoping rod.
Tighten with ratchet handle.
11. Attach desktop to end of articulated swing arm and secure by tightening
ratchet handle.
INSTALLATION PROCEDURE
READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION
STAND ASSEMBLY OPERATION
1. Remove Hex Head Cap Screws from
stand assembly and place tube over
the No-Holes Mount Base.
2. Thread (2) Hex Head Cap Screws
with (2) Lock Washers through tube
and into front and rear of No Holes
Mount post at bottom of tube. (A)
3. Raise inner rod to desired height.
Thread (2) Hex Head Cap Screws
with (2) Lock Washers into front and
rear holes at top of tube. (B)
4. Use provided Hex Key to tighten (4)
Hex Head Cap Screws to ensure
secure positioning.
RATCHET CLAMP OPERATION
B
A
Insert the ratchet handle through the
unthreaded side of the articulated swing
arm and tighten. Going through threaded
side first will not allow the arm to tighten
properly
To adjust, pull handle out (B) and rotate
counter clockwise (A), release and tight-
en. If needed, use 1/8” hex head wrench
for adjustment (C)
Ratchet handles are spring loaded and
can be readjusted to tighten.
NOTE:
NOTE:
A
B
C
