8
www.jotoimagingsupplies.com 1-800-565-5686 Blaine, WA | Las Vegas, NV | Antioch TN | Coquitlam, BC | Brampton, ON
Operating Process
Pressing a Mug
1.) Adjust height inside element for drinkware.
2.) Turn ON the individual power switches for the mug elements you wish to use.
3.) Set the appropriate Press Temperature, and Time.
4.) Tape your imaged transfer/sublimation paper to your mug with heat tape.
5.) Set the pressure. To do this, place a blank drinkware into the mug element.
Adjust the pressure knob until the drinkware fits snuggly in the element (just
enough pressure so that the mug cannot be moved once press is closed).
Turn pressure knob counter-clockwise to tighten and clockwise to loosen.
6.) Wait until current temperature is the same as set temperature. Once the mug
press is at temperature, place drinkware into the press. Close the mug press.
7.) Timer will start counting down. The press will beep when the set time has
lapsed. When mug press beeps, open mug press and take out drinkware.
Note: Ensure the timer starts immediately after closing the press. If it does
not, take the bottle out & wait for the temperature to go up to the set temp.
8a.) For sublimation, peel immediately and dunk into warm-cold water to stop the
sublimation process.
8b.) For Hard Surface Papers, dunk in warm water-cold water. Then wait until the
mug is cold before peeling.
