9
www.jotoimagingsupplies.com 1-800-565-5686 Blaine, WA | Las Vegas, NV | Antioch TN | Coquitlam, BC | Brampton, ON
Operating Instructions
Pressing a cap
1.) Turn ON the Power Switch.
2.) Set the appropriate Press Temperature, and Time.
3.) Tape your imaged transfer/sublimation paper to your cap/substrate
with heat tape.
4.) Set the pressure. To do this, place a blank cap/substrate into the cap press.
Adjust the pressure knob at the bottom of the press until the cap fits snuggly
when press is closed.
It is recommended that you use medium-high pressure for transfer papers and
transfer vinyls.
For sublimation, light pressure is required. Turn pressure knob counter-clockwise
to raise the base plate (to increase pressure or turn the know clockwise to lower the base
plate (to decrease pressure).
5.) Wait until cap press reaches the set temperature. Once the
press is at temperature, place cap/substrate into the press. Close the press.
6.) Timer will start counting down. The press will beep when the set time has
counted down to 3. The auto-release function will activate once timer reaches
zero.
7.) Peel paper immediately or as suggested by the product instructions.
Note: Do not obstruct the heat press when auto release function is active. Auto
release will be automatically activated after counter reaches zero. Beware of
moving parts.
