20
ZDE 199 007 105 03/2013
0
Insert the kingpin sensor (15) so far into the
hole until it rests on the gauge (16).
Tighten the grub screw (14) to the specified
torque.
The lines in the area of the kingpin sensor must be
routed closely along the main rib. The positions and
line routes can be found in the overview in Fig. 1
and 2 on page 14/15.
Take care not to damage any lines when the cable
ties are tightened.
6.8 Removing the locking sensor
JSK 40/JSK 42
To remove the locking sensor, the handle must be
removed.
0
Unhook the double spring (17).
Caution! Risk of injury!
When installing the double spring, ensure that this
is carried out as shown in the figure.
0
Undo the hexagon nut (18). During installation,
use the hexagon nut supplied with the repair kit
3
0
0
0
2
1
3
4
5
6
7
8
3Nm
16
15
14
JSK_12_016
1/2´´
1/2´´
SW2.5
1
0
0
0
0
2
0
0
0
0
17
JSK_12_017
65Nm
18
JSK_12_018
1/2´´
1/2´´
SW18
SW 24
6 Repair work
