5 Front Wheel Locks
The front wheels can be set to swivel or lock.
• To lock the front wheels, rotate each wheel set so that it points forward.
• Pull up on the red locking lever to engage the swivel lock.
See Figure 5.1.
• To unlock the wheels (swivel mode) push down on the lever.
Page 2
6 Rear Wheel Brakes
• Always engage rear brakes before placing an infant car seat or removing an infant car seat from the stroller.
• To engage the brakes, push down on BOTH of the red brake levers until the brake snaps in place.
See Figure 6.1.
• Check that BOTH wheel brakes are properly engaged.
• To release the brakes, lift up on BOTH brake levers.
See Figure 6.2.
!
WARNING
Always make sure BOTH wheel brakes are engaged when stroller is not being pushed so that the stroller will not roll away. Never leave stroller
unattended, especially on a hill or incline, as the stroller may tip over or slide.
7 Installing the Parent Tray
• Position the two hooks on the parent tray so that they fit over the rear frame bar below the handle bar. Align the holes of the parent tray with
the push pins on the frame bar and be sure these pins pop into the holes on both hooks. Check to be sure the tray is secure.
See Figure 7.1.
IMPORTANT NOTE
The following are the compatible infant car seat models that the Roo will accommodate:
For the most updated list of compatible infant car seats, please check our website at www.joovy.com.
!
WARNING
Always make sure the child is properly buckled into the infant car seat. Use of the stroller with infant in the infant car seat weighing more than
35 lbs(15.88 kg) will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition.
8 Installing the Infant Car Seat Adapters
This stroller is compatible with Chicco®, Graco®, and Peg Perego® infant car seats. Identify the infant car seat adapters by the affixed labels.
The Chicco® seats mount directly onto the stroller frame and DO NOT require an adapter.
NOTE:
For all of the following installations, the instructions assume that you are standing behind the stroller’s handlebar.
Chicco® Infant Car Seats
NOTE:
You DO NOT need an adapter for Chicco® infant car seats.
• The Chicco® infant car seat should be positioned onto the frame so that it is facing toward the LEFT. Lower the infant car seat into the frame
until it clicks into place.
See Figure 8.1.
• Pull up on infant car seat to ensure it is secure.
• To remove the infant car seat, pull the release lever (the same lever used to release the car seat from their base) and lift up.
Graco® and Peg Perego® Infant Car Seats
Installation for these infant car seats requires additional adapters that attach to the built-in brackets. The Graco® adapter includes molded
guides.
See Figure 8.2.
The Peg Perego® adapter is the one WITHOUT any guides.
See Figure 8.3.
• The built-in brackets have holes on the RIGHT side. Position the adapter with the bend of the adapter facing down and insert each leg of
the adapter into the holes of the built-in brackets. Push each leg fully into its bracket until they click into place.
See Figure 8.4.
• Pull on each leg of the adapter to ensure they are secured into position.
• Lower the infant car seat into frame section until it clicks into place. The infant car seat should be positioned onto the frame so that it is facing
toward the RIGHT.
See Figure 8.5 and 8.6.
• Pull up on infant car seat to ensure it is secure.
• To remove the infant car seat, pull the release lever (the same lever used to release the car seat from their base) and lift up.
•
Chicco® KeyFit 30
•
Graco® SnugRide™ 35
•
Peg Perego® Primo Viaggio SIP 30/30
