Joovy 73X Series, Инструкция по эксплуатации

Страница: 13 / 20

Room Instruction Manual
• Failure to follow these warnings and the instructions could result in
serious injury or death.
• FALL HAZARD: To prevent death or serious injury, always keep child
within arm’s reach.
• Never leave child unattended.
• The changing table is designed for use ONLY with this Joovy playard. DO
NOT use on any other products or surfaces.
• The weight limit for the changing table is 25 lbs (11 kg). DO NOT use
changing table as storage.
• DO NOT use changing table as a sleeping or play area.
• DO NOT use changing table if it is damaged or broken.
• STRANGULATION HAZARD: Child can lift the changing table and get
neck caught between changing table and playard frame. ALWAYS remove
changing table when child is in the playard.
• Before each use, make sure the changing table is properly secured by
pushing down firmly in the center of the changing table.
CHANGING TABLE
Read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE.
• Ensure the playard is erected. The changing table can be used with or without the bassinet attached.
• Locate the changing table and the changing table attachment clamps.
• Orient the changing table so it is upside down (white side down).
• Take one changing table attachment clamp and identify it by referencing the lettered labels on the ends of
the tube.
• Identify the corresponding letters on the tubes located in the sleeves on each long side of the changing table.
• Orient the attachment and tube so the corresponding letters match and slide the attachment clamp through
the sleeve on the narrow end of the changing table so both plastic clamps are on the outside of the sleeve.
DO NOT snap the tubes together yet. Be sure to slide the attachment clamp through the sleeve in between
the narrow sides of the changing table. Repeat this procedure on the other side. See Figure 25.
• Starting with the tubes lettered “A”, insert the tapered tube into the open tube then, press the button to
completely insert the tubes until they snap into place. See Figure 26. Repeat this procedure on the tubes
lettered “B”.
• Orient the changing table so the tubes labeled “C” and “D” are closest to you. Simultaneously angle both
open tubes onto the corresponding tapered tubes. See Figure 27. Once the tubes are partially attached,
press the button on one side and snap that tube into place. Then snap the tube together on the other side.
• Fold the fabric on the outside of each side of the changing table over the tubes and secure each of the six
snaps. See Figure 28. Repeat this step on the other side.
• Grab the changing table by the large plastic clips with the white cover facing away from you. Attach these
clips onto the narrow rail of the playard. See Figure 29.
• Flip the changing table over onto the top rails. Firmly snap the changing table attachment clamps onto the
plastic bassinet attachments that are installed on the long rails of the playard. See Figure 30. You will need
to push down forcefully on each side to snap the attachments into place. Check to ensure all four
attachments are secured on the rails.
!
WARNING
Installing and Using the Changing Table
Page 12