Jonsered ST2261e, Руководство оператора

Страница: 19 / 28

2. Remove the tensioner spring (A) attached to the
drive belt tensioner arm (B).
A
B
C
D
E
H
F G
I
J
3. Remove the return spring (C) holding the swing plate
(D) in place.
4. Remove the arm bolt (E) and drive belt tensioner
arm.
5. Remove the pulley bolt (F), engine pulley (G) and
drive belt (H) from the engine.
6. Remove the top bolt (I) holding the swing plate to the
frame
7. Pivot and hold the swing plate away from the product
and remove the drive belt from the drive pulley (J).
To install the drive belt
1. Pivot and hold the swing plate (D) away from the
product.
A
B
C
D
E
H
F G
I
J
2. Put the drive belt (H) onto the drive pulley (J).
Note Make sure that the drive belt is routed in the
drive pulley groove properly before you lower the
swing plate.
3. Install and tighten the top bolt (I).
4. Put the drive belt in the grove of the engine pulley
(G) before installing on the engine shaft.
5. Install the pulley bolt (F) and attach the engine pulley
on the engine. Tighten the pulley bolt (30-35 Ft.
Lbs. / 41-47 Nm).
6. Install the drive belt tensioner arm (B) and tighten
the arm bolt (E) on the engine.
7. Install the return spring (C) on the swing plate.
8. Install the tensioner spring (A) on the tensioner arm.
9. Operate all controls to make sure that the drive belt
is installed correctly and that all components are
moving correctly.
To install the belt cover
1. Install the belt cover (B) on the frame (C) and tighten
the two screws (A).
C A
B
2. Install the discharge chute.
797 - 001 - 19