Jonsered SM 2055 E, Руководство оператора

Страница: 19 / 36

English –
19
INSTALLATION
One-man sawmill with chain saw
engine
Install the handlebar (FIG. 32)
The handlebar with the throttle is installed on the saw
carriage using two bolts.
FIG. 32
FIG. 34
FIG. 33
D
Install scale pointer and scale
(FIG. 34)
Install the scale pointer and scale as follows:
1. The scale pointer is installed using two self-tapping
screws (A).
2. Insert the scale through the scale pointer from
above. The scale’s greatest value should point
downwards. Screw the scale into the saw carriage
(B).
3. Measure the distance between the lower part of the
saw chain (D) and the log bolster. Set the scale
pointer so that the scale has the same value.
4. Bolt on the scale pointer.
5. Check that the saw chain moves freely over the long
(E) and short (C) log supports when the red mark
can be read on the scale.
Install throttle and cable (FIG. 33)
The throttle and lever are installed in the chain saw’s
handle. The loop (A) is positioned inside the handle.
The washers (B and C) are screwed into position.
When the throttle’s mounting is installed, the throttle
lock on the saw is pressed in. Connect the cable from
the handlebar into the lever and adjust it using the
screw nipple. When the throttle on the handlebar is not
activated, the play between the throttle on the saw and
the lever (D) should be approximately 1 mm.
D
1 mm
C
A
B
E
C
B
C
A