Jonsered G?2043, Руководство оператора, Страница: 11 / 32

English
– 11
ASSEMBLY
Fitting the main body
Connect the engine (A) to the tube (B) with four screws (C).
Fitting the J-handle
• Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
• Slide the spacer into the slot in the loop handle.
• Fit the nut, washer and screw.
• Attach the J-handle to the loop handle using the three
screws, as shown.
• Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
Connecting throttle cable and stop
switch wires
1 Remove the air filter cover.
2 Insert the throttle cable (A) to the end of the adjuster (B).
3 Position the slotted fitting (C) on the carburettor so the
recessed hole (D) for the cable lug (E) is away from the
cable adjuster sleeve.
4 Rotate the carburettor throttle cam and slip the throttle
cable through the slot in the slotted fitting, making sure the
cable lug drops into the recessed hole.
5 Operate the throttle trigger a few times to make sure that
it works correctly.
6 Adjust the cable adjuster sleeve so the stop on the
carburettor throttle cam just contacts the throttle stop and
the cable position keep 1-2 mm play between the cable
lug and the slotted fitting when the throttle trigger is fully
depressed.
7 When the throttle cable is adjusted correctly, tighten the
lock-nut (F) and the M3 screw (G).
8 Plug the stop switch wires (H) into the matching
connectors from the engine. Note that wire polarity is not
important.
!
WARNING! Only grass blades/grass cutters
or trimmer heads/plastic blades may be used
when the J-handle is fitted. Saw blades must
never be used with the J-handle.
A
B
C
A
B
G
C
E
D
F
1-2mm
H