English
– 23
Maintenance
Checking and adjustment of the
cutting unit’s ground pressure
To achieve the best cutting results the cutting unit should
follow the underlying surface without pressing too hard
against it.
Pressure is adjusted using a screw and spring on each side
of the Rider.
1
Check the air pressure in the tyres 60 kPa/0.6 kp/cm
2
/8.5
PSI.
2
Place a set of bathroom scales under the cutting unit’s
frame (front edge) so that it rests on the scales. If
necessary a block can be placed between the frame and
scales so that the support wheels do not bear any weight.
3
Adjust the unit’s ground pressure by screwing in or out the
adjusting screws located behind the front wheels on both
sides.
The ground pressure should be between 12 and 15 kg (26.5-
33 lb).
Checking the cutting unit’s
parallelism
Check the cutting unit’s parallelism as follows:
1
Check the air pressure in the tyres 60 kPa/0.6 kp/cm
2
/8.5
PSI.
2
Place the machine on a flat surface.
3
Measure the distance between the ground and cutting
unit’s edge at the front of the cover.
The cutting unit should have a slight slant, with the rear edge
2-4 mm (1/8”) higher than the front edge.
Adjusting the parallelism of the
cutting unit
1
Remove the front hood and right-hand fender.
2
Unscrew the belt shield.
3
Undo the nuts on the lift strut.
4
Screw out (extend) the stay to raise the rear edge of the
cover.
Screw in (shorten) the stay to lower the rear edge of the
cover.
5
Tighten the nuts against each other after adjustment.
6
On completion of the adjustment the unit’s parallelism
should be re-checked.
7
Screw on the belt shield.
8
Fit the right-hand fender and the front hood.
Содержание FR 2318FA
Страница 33: ......
Страница 34: ......
Страница 35: ......
Страница 36: ... z X 6 6w 2014 07 01 z X 6 6w 1156992 26 Original instructions ...