27
ENGLISH
Remote control programming
The supplied remote control can also be used to control another device equipped with an infrared remote
control (for example the television).
To make the remote control communicate with the TV you need to follow these steps:
1.
Position the two remote controls of decoder and TV facing each other so that the two emitters look
at each other without being obstructed
2.
Press the
SET
button for 3 seconds on the remote control until the red LED lights up and stays on.
3.
Press the key to be associated on the decoder remote control within 10 seconds.
4.
Press the button to be associated on the TV remote control within 3 seconds. If the signal is
received by the remote control, the red LED will flash 3 times and then remain on.
5.
Press
SET
to confirm.
6.
Repeat these steps for each button on the remote you want to configure
Tips:
•
at the end of the programming process, check whether the key has been associated before
continuing with the next
•
in order to avoid confusion, associate the keys with the same function, for example in point 3 press
the
ON / OFF
key on the remote control of the receiver and in point 4 press the same key on the
remote control of the TV,
Attention:
it is possible to associate only the buttons of the remote control supplied inside the white
rectangle (
ON / OFF
,
TV / AV
;
VOL +
and
VOL-
).
SET
function key and cannot be associated.
Functions not available
Some functions may not be available in this case a window like the one shown will appear.
