27
ENGLISH
It is possible to continue to use the wood fire even during a power Black Out.
WARNING
When the wood logs are almost burnt out, reload the fireplace again with a small amount
of wood, leaving the ash pan open again
When the wood has burnt out and there are still some charcoal, add the maximum quantity
of wood, or the amount required.
The fireplace’s capacity and the duration of the fuel are regulated by the quantity of
combustion air.
•
COMBUSTION
For this type of functioning, except when loading, the fireplace door must always be closed
to ensure correct combustion, and to prevent combustion fumes from escaping into the
room.
Disassembly or tampering with the closure, unauthorised by Jolly-mec, will
cause invalidation of the warranty.
If you open the fireplace door while it is functioning, to load wood or any other operation,
it is compulsory to use protective gloves and perform such operations when there are only
cinders in the fireplace and no actual flames.
Never open the door quickly, as this may cause fumes to escape.
Open the door slowly and just a little, before opening it completely.
Only add wood when there are cinders otherwise there could be a risk of combustion
products escaping.
Never use larger quantities of wood than those recommended:
load 2 blocks of wood (D)
(without exceeding 2/3 kg/h of wood).
To prevent less than optimal combustion, the ashes must be removed very carefully using
the designated tool, so that the grid does not get clogged and the air supply can flow freely.
•
END OF COMBUSTION
(This applies even when the system is switched off)
This phase is reached when the wood has burnt out and there is no combustion with or
without flames.
The damper can be set to 4 positionsi: I, II,III and IIII. It allows the correct adjustment of combustion according to flue draught (which
also varies according to atmospheric conditions). The user should become familiar with damper use in order to optimise stove operation.
To adjust the damper:
• turn the knob until the notch is in the desired position.
The accurate adjustment of the smoke damper is essential to the proper operation of the fireplace.
CLOSED POSITION (I)
(
Fig. 1
):
Operating with optimal draught to achieve the declared rated
thermal output.
HALF-CLOSED POSITION (II o III)
(
Fig. 2, Fig. 3
):
• Operating with suboptimal draught and suboptimal combu
-
stion (e.g.: dirty glass)
• Operating with low quantities of wood
OPEN POSITION (IIII)
(
Fig. 4
):
• During ignition
• On opening the door to load the wood whilst in operation
• Operating with suboptimal draught and suboptimal combu
-
stion (e.g.: dirty glass)
•
USING THE DAMPER
C
D
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Содержание AERJOLLY EVO S Series
Страница 47: ...47 ENGLISH NOTES...
