37
36
centre-line of seating position
Pull to increase tension
Top Tether Use
Always connect the snap hook securely to the
anchorage fitting.
Adjust the tether as shown.
The anchor fitting must be aligned as shown
unless stated otherwise in the vehicle owners
handbook.
If drilling a new hole, select a position on the
centre line of the seating position, and no
closer than 100 mm from the front edge of the
parcel shelf.
In some vehicles without a fixed parcel
shelf an extension tether strap may be
required. These are available in several
different lengths and can be obtained
from child restraint retail outlets.
WARNING
Tether Anchorage Installation
If the car is fitted with a child restraint an-
chorage point:
Locate the anchorage point behind the rear
seating position (consult the vehicle owners
handbook for location of the anchorage point).
Remove the thread plug from the parcel shelf/
floor/roof and install the attachment bolt as
shown opposite.
CAUTION:
DO NOT OVERTIGHTEN THE ATTACHMENT
BOLT. MAXIMUM TORQUE 20Nm.
CHILD RESTRAINTS MUST NOT BE ATTACHED TO UNSOUND METAL OR
WOOD OR SYNTHETIC STRUCTURES. WHEN DRILLING THE 9 MM HOLE DO
NOT DRILL THROUGH FUEL LINES, FUEL TANKS, ELECTRICAL WIRING, OR
RADIO SPEAKERS. WEBBING STRAPS MUST BE PROTECTED FROM SHARP
CORNERS AND EDGES.
THE ANCHOR FITTING MUST BE USED ONLY AS DESCRIBED ABOVE. IT
MUST NOT BE HOOKED ONTO ANY OTHER OBJECT.
Attachment
Bolt
Lock
Washer
Spacers
(if
required)
Anchor
Fitting
Vehicle
Metal
Structure
Vehicle
Trim
FRONT OF VEHICLE
