B.
To set the correct time, press the
Time Set Button (7) and Hour Set
Button (10), or Minute Set Button (9),
together, until the correct time is
displayed.
C.
Open the clock Battery Door (14)
at the backside of the unit and put in
a 6LR61/6F22 (or equivalent) 9-volt
battery. The purpose of this battery
is to store the information relating
to alarm time and to keep the clock
functioning in the event of discon-
nection from the mains supply or
power interruption. Should this
occur, the clock would continue to
keep time, but will not display.
PLEASE NOTE
: When operating from
battery only, the clock will only re-
main accurate for a short period of
time.
It is important that the mains supply
is restored as soon as possible.
ALARM TIME SETTING
A.
Press the Alarm Set Button (6) and
simultaneously press the Hour Set
Button (10) or Minute Set Button (9)
as appropriate until the required
alarm time is reached.
B.
To double check the alarm time,
simply press the Alarm Set Button
(6) then the display will show the
pre-set alarm time.
RADIO OPERATION
For AM reception this unit uses an
internal directional aerial, rotate the
unit for best reception. For FM re-
ception, the wire FM Antenna (12)
on the back of the unit should be
fully unwound.
A.
Set the Function Selector (11) to
the “ON” position.
B.
Set the Waveband Selector (4) to
the required waveband.
C.
Use the Tuning Control (3) to se-
lect the desired station.
D.
Adjust the Volume Control (2) to
the desired listening level.
E.
To turn off the radio, set the Fun-
ction Selector (11) to ”OFF”.
If the radio does not switch off this
may be caused by inadvertent ope-
ration of the Sleep Set Button (8).
To cancel this, press the Snooze
Button (5) once.
WAKE TO RADIO
Having selected your desired station
and adjusted the desired listening
level, proceed as follows:
A.
Follow the instructions for “ALARM
TIME SETTING” above.
B.
When the desired alarm time has
been selected, set the Function Se-
lector (11) to the “AUTO” position.
C.
The radio will switch on automa-
tically at the pre-set alarm time.
D.
The alarm can be temporarily
stopped for approximate 9 minutes
by pressing the Snooze Button (5)
once.
E.
Depress the Alarm Set Button (6)
to turn off the radio.
The alarm will activate again after
24 hours unless the Function Selec-
tor (11) is set to “OFF”.
WAKE TO ALARM
A.
Follow the instructions for “ALARM
TIME SETTING” above.
B.
When the desired alarm time has
been selected, set the Function Se-
lector (11) to the “AUTO position.
C.
Turn the Volume Control – Buzz
On / Off (2) fully clockwise to select
the BUZZ function.
9
