13
Parts:
A. Blades
B. Glass shade
C. Motor unit
D. Light shade plate
E. Blade fastening compartments
F. Bulb socket
G. Hanging section
H. Terminal cover
L. Hanging section fastening pin
M. Ceiling connection
N. Appliance connection cables
O. Electrical mains connection cables
P. Infrared sensor
Q. Appliance power cables
R. Electrical unit
S. Remote control
T. OFF fan
U. ON/OFF light
V1. ON - Slow rotation
V2. ON - Medium rotation
V3. ON - Fast rotation
Y. Key direction of rotation
Z. Rotation sensor selector
Assembly, installation and electrical con-
nection operations must only be carried
out by
SPECIALIST, QUALIFIED STAFF
.
Fig.1
Loosen the 3 screws blocking the
plate (D) (without removing them).
Fig.2
Turn the plate (D) in an anti-clock-
wise direction by freeing it to move it as
much as necessary to access the 3 blade
(E) fastening screws.
Fig.3
Insert the blades (A) in the slots on
the side of the motor unit;
Fig.4
So that the blade (A) holes corre-
spond to the fastening compartment (E)
holes.
Fig.5
Fully tighten the 3 fastening screws
for each blade.
ATTENTION
: Assemble all 5 blades in the
same direction, all curving towards the
right or all curving towards the left.
Fig.6
Re-assemble the plate (D) by cen-
tring the screws on the 3 holes, turning
the plate in a clockwise direction and fir-
mly fastening it by tightening the 3
screws.
Fig.7
Screw in the bulb NOT SUPPLIED on
the bulb socket (F).
Fig.8
Assemble the glass shade (B) by en-
suring the metal protrusions on the plate
(D) correspond with the glass compar-
tments and turn in a clockwise direction
until locked.
Fig.9
Insert the hanging section (G) in the
terminal cover (H) and pass the 4 wires
(Black-Blue-White-Brown) through the
hanging section (G), out of the appliance.
Fig.10
Fasten the hanging section (G) to
the appliance unit (C) with the through pin
(L) and then insert the safety ring on the
pin.
Fig.11
Fasten the fan connection (M) to
the ceiling with sufficiently sized plugs
(NOT SUPPLIED) to support the weight of
the appliance.
Fig.12
Pass the 4 electrical wires through
the slot in the cover.
Fasten the appliance to the ceiling, ensu-
ring the holes on the edge of the ceiling
connection (M) correspond to the 4 holes
of the terminal cover (H) and lock all in
place with the 4 screws.
Electrically connect the appliance with the
wires (N-Q) on the electrical unit (R). Blue
wire with Blue, White with White, Black
with Black and Brown with Brown. (TERMI-
