Johnson Kosmo, Инструкция по эксплуатации

Страница: 19 / 24

19
OPERATING INSTRUCTIONS
Components
A Body device
B Blades
C Switch 0-1-2
D Cutting size adjuster (0.8-1.1-1.4-1.7-
2.0 mm)
E 4 spacer combs (3-6-9-12 mm)
F Adapter
G Adapter cable socket
H Plug for connection to the mains
I Lubricating oil container
The cleaning brush
M Contact pin for charging in the base
N Plug for direct connection to the net-
work
P Guides for inserting spacers
R Charging base
S Base seat for adapter cable socket
T LED display
Special warnings
The hair cutter while it is in use or char-
ging, it is normal for it to heat up. Before
use, pay close attention to the orientation
of the blade. The battery must not be re-
charged at temperatures below 0 ° C or
above 40 ° C. Do not recharge the battery
in direct sunlight or near a heat source.
Do not leave the battery charging conti-
nuously for more than 48 hours. Do not
handle the appliance by holding it only by
means of the cable, as it could become di-
sconnected and falling damaged. Keep the
appliance away from children and unable.
If the appliance shows any anomaly, do
not tamper with the appliance but contact
an authorized service center.
Charging the battery
Place the appliance (A) in the charging
base (R) after inserting the adapter socket
(G) in the seat (S) of the base (R) as shown
in fig. (3) then insert the plug (H) into a su-
itable socket to receive it. The LED display
(T) lights up and in addition to indicating
the percentage of charge, a red icon also
appears indicating that the appliance is
energized, see fig. (1) on reaching 100
(full charge) disconnect the plug (H) from
the power socket.
Attention
Place the appliance and its base, while re-
charging, away from sinks and make sure
that any splashes of water cannot, even
accidentally, wet it.
It is forbidden to use the unit with wet or
damp hands.
Activation
To activate the hair cut, move the switch
(C) to position 1, low speed, or to position
2 high speed, (on the display (T) the icon
with the word “turbo” fig.2 lights up) choo-
sing the most suitable for your needs.
Adjustment of the cutting size
The cutting length is easily adjustable in
various sizes. Different cutting lengths are
possible: from 0.8 mm to 2 mm directly
from the appliance by setting the size cho-
sen with the regulator (D), and from 3 mm
to 12 mm by mounting one of the spacer
combs (E) according to the chosen length
inserting them in the special guides (P) see
fig. (4)
Use of the appliance powered by the
built-in battery
Choose the cutting size as described in
the point “cutting size adjustment”. Hold
the appliance (A) set the switch (C) to 1 or
2 according to the desired speed (1 low
speed, 2 high speed and the icon with the
wording “turbo” fig.2 lights up on the di-
splay (T) thus activates the cutting action,
to interrupt it, move the switch (C) back to
position 0.
Use of the appliance with power from
the mains
Choose the cutting size as described in
the point “cutting size adjustment”. Insert
the socket (G) of the cable adapt (F) into
the plug (N) located on the bottom of the
appliance as shown in the figure (5) and
insert the plug (H) of the adapter (F) into
a suitable power socket for receive it, the
LED display lights up and in addition to
indicating the percentage of charge, a red
icon appears indicating that the applian-