Johnson AB Trainer, Руководство пользователя, Страница: 7 / 10

11 12
Assembly
A) Open the machine, hold the front support post (2) to front side then
insert the pin (14) into the hole of the front bracket of main frame (1).
B) Insert the adjusting foot (3) to the front support post(2) and lock with
pin B (15) at your desired location.
STEPS
Assembly Step 1
A) Insert the foam A (7) into the front tubes of main frame (01) and install
the foam A (7) to the front bars of sliding base (5).
B) Do the same of the foam B (8) to the rear bars of sliding base (5).
REMARK: If it is difficult to insert foam, plsease add some soap water
on the tube
Assembly Step 2
Attach the handle Set (4) to the main frame (1). Lock w[th curve washer
(13) , allen bolt (12) and fasten using the Allen key.
Assembly Step 3
Slide the computer (6) into the bracket of handle set (4), then connect the
computer lower wire (29) with sensor upper wire (30).
Assembly Step 4