TFP110
Page 6 of 6
NATIONAL FIRE PROTECTION ASSOCIATION and NFPA are registered trademarks of National Fire Protection Association;
MONEL and INCONEL are registered trademarks of Special Metals Corporation;
TEFLON is a registered trademark of DuPont
1400 Pennbrook Parkway, Lansdale, PA 19446 | Tel1-215-362-0700
© 2020 Johnson Controls. All rights reserved. All specifications and other information shown were current as of document revision date and are subject to change without notice.
Limited
Warranty
For warranty terms and conditions, visit
www.tyco-fire.com.
Ordering
Procedure
Contact your local distributor for avail-
ability. When placing an order, indicate
the full product name and Part Number
(P/N).
Sprinkler Assemblies with NPT
Thread Connections
Specify: Series TY-L (specify SIN),
(specify K-factor), (specify Upright,
Pendent, or Recessed Pendent) Sprin-
kler, Standard Response, Standard
Coverage, (specify) temperature rating,
(specify) finish or coating, P/N (specify
from Table C)
Recessed Escutcheon
Specify: Style (specify) Recessed
Escutcheon, (specify material) with
(specify*) finish, P/N (specify*)
*Refer to Technical Data Sheet TFP770
Sprinkler Wrench
Specify: W-Type 9 Sprinkler Wrench,
P/N 56-000-1-849
Specify: W-Type 10 Sprinkler Wrench,
P/N 56-000-1-948
Wax Sticks (for retouching wrench-
damaged wax coating)
Specify: Series TY-L Sprinklers,
(specify color), color coded Wax Stick
for retouching, (specify) temperature
rated, P/N (specify):
Red for 165°F (74°C) . . . . . . . P/N 56-065-1-155
Blue for 212°F (100°C)
and 280
°
F (138
°
C) . . . . . . . . . P/N 56-065-1-286
Note:
Each wax stick is suitable for
retouching up to twenty-five sprinklers.
The wax used for 280°F (138°C) sprinklers
is the same as for 212°F (100°C)sprinklers.
Therefore, the 280°F (138°C) sprinkler
is limited to the same maximum ceiling
temperature as the 212°F (100°C) sprinkler,
which is 150°F (65°C).
completed, to verify the integrity of the
corrosion-resistant coating. Thereafter,
annual inspections per NFPA 25 should
suffice; however, instead of inspecting
from the floor level, a random sampling
of close-up visual inspections should
be made so as to better determine the
exact sprinkler condition and the long-
term integrity of the corrosion resistant
coating, as it may be affected by the
corrosive conditions present.
The owner is responsible for the
inspection, testing, and maintenance of
their fire protection system and devices
in compliance with this document, as
well as with the applicable standards
of the NATIONAL FIRE PROTECTION
ASSOCIATION, such as, NFPA 25, in
addition to the standards of any other
authorities having jurisdiction. Contact
the installing contractor or product
manufacturer with any questions.
It is recommended that automatic
sprinkler systems be inspected, tested,
and maintained by a qualified Inspec-
tion Service in accordance with local
requirements and/or national codes.
SIN
111 5.6K UPRIGHT (1/2 in. NPT) TY3111
112 5.6K PENDENT (1/2 in. NPT) TY3211
101 8.0K UPRIGHT (3/4 in. NPT) TY4111
102 8.0K PENDENT (3/4 in. NPT) TY4211
106 8.0K UPRIGHT (1/2 in. NPT) TY4811
107 8.0K PENDENT (1/2 in. NPT) TY4911
SPRINKLER
FINISH
1
NATURAL BRASS
6
WAX COATED
165°F TO 280°F ONLY
7
LEAD COATED
8
WAX OVER LEAD
165°F TO 212°F ONLY
9
CHROME PLATED
TEMPERATURE
RATING
165
165°F (74°C)
212
212°F (100°C)
280
280°F (138°C)
P/N 53 - XXX - X - XXX
TABLE C
SERIES TY-L PENDENT AND UPRIGHT SPRINKLERS
PART NUMBER SELECTION
