Johnson Controls Tyco KT-1, Руководство по установке, Страница: 51 / 56

2. In the Cloudvue Registration pane, in the Cloudvue Partner and Cloudvue Account
Name fields, enter the partner and account name, and from the Cloudvue Data Center
list, select the data center.
Note: To find out this information, contact your Cloudvue administrator.
3. Click Save .
Result
• If the Cloudvue partner is invalid, a red banner displays the message Invalid Partner Code
and the controller cannot restart.
• If the Cloudvue account name is invalid, a red banner displays the message Invalid Account
Name and the controller cannot restart.
• If the information is valid, the controller's Kantech shield LED makes three short blue flashes
and the controller restarts in cloud mode.
What to do next: After you configure the controller in cloud mode, you can add it to the Cloudvue
system. To add the controller in Cloudvue, see Adding the controller to the cloud .
Configuring the controller using the KT-Finder
Download the KT-Finder for free from http://www.kantech.com . Use the KT-Finder application to
configure the controller over the LAN or the WAN.
1. Exit all EntraPass applications.
2. Make sure the controller is in factory default DHCP mode. To reset the controller, see
Resetting the controller .
3. To open the KT-Finder, go to Start > All Programs > EntraPass Edition > Server > KT-Finder .
Note: If you try to open the KT-Finder when EntraPass is open, an error message
appears.
4. In the KT-Finder Wizard window, from the Device list, select KT-1 .
5. In the MAC address field, type the MAC address of the KT-1, and click Connect . When the KT-
Finder finds the controller, the following message appears: Configuring the KT-1 with the
KT-Finder .
6. In the EntraPass Gateway pane, in the EntraPass IP Address field, type the IP address. For
more information, refer to the EntraPass Administration Guide .
7. In the Ethernet configuration pane, from the Protocol list, select UDP or TCP .
8. Optional: If you selected UDP , in the Port field, enter a port number.
Note: Change the port number only when you have more than one controller at the
same remote site.
9. Click OK .
10. Repeat the steps for each controller at this site.
Adding the controller to the cloud
Before you begin: Before you add a controller to Cloudvue, you must initialize it so that the
controller receives its default configuration from the cloud. If the controller is initialized, the L2
(Lock 2) LED turns on. If the controller is not initialized, you cannot save your configuration in
Cloudvue.
1. Log on to Cloudvue at https://cloudvue.com/login .
2. In the right pane, click Account .
3. Click the Devices tab.
4. Click ADD NEW DEVICE , and from the list, select Add Access Control Device .
5. Enter the following information about the controller:
- Controller Name : Enter a name to identify the controller easily.
- MAC Address : Enter only the numbers. Do not enter dashes or colons.
- Serial Number : Enter the controller's serial number.
6. From the Location list, select an existing location, or to add a new location, select ADD A
NEW LOCATION and enter the location details.
KT-1 One-Door Controller Installation Guide 49