Installing the rubber cable seal in to the NPT pendant cap
1. Securely place the rubber cable seal (2) (Figure 5) into the pendant
cap (3) (Figure 6).
Figure 6
2. Place the mount adaptor (1) (Figure 6) on to the NPT pendant cap
(3) (Figure 6) and align the holes on the mount adaptor with the
holes on the NPT pendant cap.
3. Insert the three security screws into the three holes and use the
Torx security L-Key to securely attach the screws and the mount
adaptor to the NPT cap.
Security
Mounting the camera to the RHOSW accessory
1.
Hold the large loop on the safety lanyard (2) (Figure 4) up next to
the mounting arm (1) (Figure 4).
2.
Ensure that the smaller loop on the safety lanyard is placed
around the mounting arm and then through the hole in the larger
loop so that the safety lanyard is securely attached to the
mounting arm.
3.
Remove the safety lanyard screw (3) (Figure 4) on the camera.
4.
Place the smaller loop on the safety lanyard around the screw
hole on the camera and then insert the screw to securely attach
the safety lanyard to the camera.
Mounting the camera to the RHOSW accessory (continued)
Figure 4
Inserting or removing the micro SD card
1. Remove the two screws located on the micro SD card cover (4)
(Figure 1).
Figure 5
Inserting or removing the micro SD card (continued)
2. Carefully pull open the cover to access the SD card slot (1)
(Figure 5) and insert (or remove) the micro SD card into (or from)
the camera.
Note:
It is advised that you reboot the camera after inserting the
micro SD card.
3. Secure the two screws located on the micro SD card cover.
Note:
The USB cable connection slot (2) (Figure 5) for Wi-Fi
configuration is also located under the micro SD card cover.
The Wi-Fi option allows wireless configuration of the camera at
the point of install in conjunction with the Illustra Tools app (Illustra
Wi-Fi dongle required).
Connecting the wires
This unit supports one of the following options as power supply:
1. Connect a power source.
•
AC24V wired to connector and separate RJ45 Ethernet.
OR
•
PoE through RJ45 connector. The Outdoor unit operates with
IEEE 802.3bt (71W max).
2. Connect any optional audio or digital inputs or outputs.
Note:
After connecting all cables ensure that the two screws on
the top cover are securely attached to maintain the waterproof
seal.
Installing the mount adaptor on to the NPT pendant cap
(continued)
Note:
To maintain the waterproof seal only pierce holes that are
required for the installation.
Passing the RJ45 connector through the grommet
1. Remove the plug from the grommet (1) (Figure 7) by pulling the stub
(2) (Figure 7) to create a hole in the grommet.
Figure 7
2. Insert the RJ45 cable connector (1) (Figure 8) into the insert tool (2)
(Figure 8).
3. Push the insert tool and cable through the grommet hole (3) (Figure
8).
4. Remove the insert tool from the RJ45 connector and pass the cable
through the NPT cap (4) (Figure 8).
