Johnson Controls Tyco Illustra Pro Gen4, Быстрый старт

Страница: 1 / 3

Table 2: Camera interior buttons / connections descriptions
Buttons / Connectors Description
AC24V Power connector
PoE Ethernet port
Analog out port
Audio and Alarm pins
(See Figure 3 for descriptions)
Reset to factory default (Hold for 5
seconds and then release)
Power LED indicator
Reboots the camera
Security
Q uick S tart G uide
(8200-2007-01_E)
Illustra Pro Gen4 2MP & 8MP IR PTZ Outdoor camera
(P/N IPS02-P24-OI04 & IPS08-P25-OI04)
In the box
•
1 x Illustra IR PTZ Camera
•
1 x Printed Quick Start Guide
•
1 x Printed Regulatory Document
•
1 x NTSC/PAL output female BNC cable
•
1 x 2-pin European style terminal block
•
1 x Torx 20 security L-Key & 1 x Torx 10 security L-Key
•
1 x 12-pin terminal connector for I/O function
•
1 x Safety cable (Pre-attached to the camera)
•
1 x Mount adaptor
•
3 x ¼ 20 UNC security screws
•
1 x Rubber grommet
•
1 x RJ45 Insert tool
Installation tools
•
1 x Screw driver
•
1 x Torx 20 security L-Key & 1 x Torx 20 security L-Key
•
1 x Drill
•
1 x Wire cutters
Figure 1: PG4 IR PTZ camera parts
Figure 1
Table 1: Camera part descriptions
Number Description
1 NPT Pendant Cap
2 Screw (x2) to open and lock the top cover
3 Top cover
4 SD Card Cover
5 Camera lens
6 Camera head
Quick reference
•
Default IP: 192.168.1.168 (DHCP enabled)
•
Default Username / Password: admin / admin
•
Power: PoE 802.3bt 90w or AC 24V
Note: Before you power up the camera; please ensure that all
packaging has been removed, including packaging located inside
the bubble assembly.
As part of the start-up sequence the camera runs
motor calibration, this includes a 15 second 'shake' procedure.
Accessing the camera interior buttons / connections
1. Use the Torx security L-Key to remove the two screws on the
camera top cover (1) (Figure 2).
Figure 2
Figure 3: Audio and alarm pin descriptions
Figure 3
Mounting the camera
Refer to the Illustra mounting accessories webpage
https://www.illustracameras.com/products/accessories/mounts for
assistance. The following mount accessory part numbers are
applicable with the Illustra Pro Gen4 2MP and 8MP IR PTZ camera:
RHOSW, RHOLW, RHOTR, ROTRF, RHOWCA, ROENDC.