Johnson Controls TE-6800 Series, Руководство по установке

Страница: 4 / 6

NOTICE
Risque de dégâts matériels
Ne pas utiliser un paramétrage des commutateurs
différent de celui-ci illustré à la Figure 5. L'utilisation
d'autres paramètres de commutateurs risque de
provoquer un fonctionnement incorrect du contrôleur
ou d'endommager l'élément, le contrôleur [et/ou]
l'équipement contrôlé.
Warmer/Cooler Setpoint and No Setpoint
Models
For the Warmer/Cooler Setpoint and No Setpoint models,
the factory default is the LED Mode:ON described as
follows. The switch positions enable/disable the following
functions:
Table 3: Warmer/Cooler Setpoint and No Setpoint
models switch positions status
Status Description
LED Mode: OFF (LED
Disabled, but Sensor and PB
Enabled)
Switch positions are down,
up, and down. The LED
remains off at all times.
LED Mode: ON
(LED, Sensor,
and PB Enabled)
Switch positions are
factory set up, down,
and up. The controller
determines the LED mode.
LED Mode: NO PB (LED and
PB Disabled, but Sensor
Enabled)
Switch positions are all
down. LED is off, and the
PB does not function.
Figure 5: DIP Switch Positions
Table 4: Controller Compatibility with LED Mode and PB
Features Recognized by Controller Types of TE-6800 LED Mode
(Figure 5)
Features
Enabled on
TE-6800
AHU UNT1100 VAV1xx or
UNT1xx
1
VMA1200
Series
1
VMA1400
Series
1
2
LED Off 2
Sensor and
Manual
Override
No Yes Yes Yes Yes
LED On Sensor,
Manual
Override,
and LED
No No No Yes Yes
Warmer/Cooler
Setpoint
No PB Room
Sensor Only
Yes Yes Yes Yes Yes
1 For these controllers, the LED appears brighter when the manual override PB is pushed.
2 Holding the manual Override PB for more than 2 seconds may affect the sensor reading.
Temperature Setpoint
Adjust the setpoint using the setpoint adjustment dial. Rotate clockwise to raise the temperature. Rotate
counterclockwise to lower the temperature.
TE-6800 Series Temperature Sensors Installation Guide 4