Engineering manual - UniSAB III 1.10.8
001930 en 2021.06
37/346
1.2.10
Factory settings
On delivery UniSAB III is preset with factory settings for all appropriate points. Although other values
may have been entered from factory or after delivery, UniSAB III can always be reset to its factory set-
tings. A factory reset affects the following points:
•
Alarm and shutdown limits
•
Regulator settings
•
Timer setup
•
Control mode
The factory settings are stated in the tables in the sections
Alarms and shutdowns, Timers
and
Com-
pressor regulation
(Engineering manual). Before performing a factory reset, always
stop
the compres-
sor for safety reasons. Select
Setup/Configuration
/
Factory Reset
and change
Factory Reset
from
No
to
Yes
.
Now press
and within a few seconds UniSAB III will restart and display the
Favourites
/
Default
picture
shown in Fig. 1. The reset operation is complete and UniSAB III is now restored to its factory settings.
UniSAB III must then be adjusted to the actual operating conditions.
Remember to fill in the forms for ac-
tual settings before making a factory reset. These forms (Settings for UniSAB III) are included in the
back of this manual.
Содержание SABROE Unisab III Control
Страница 1: ...UniSAB III control Version 1 10 8 Engineering manual EN...
Страница 2: ......
Страница 347: ......
