background image

UL/ULC notes

The PGP9303 has been listed by UL/ULC for commercial and residential burglary applications

in accordance with the requirements in the Standards UL 634 and ULC/ORD-C634 for contacts

and switches. For UL/ ULC installations use this device only in conjunction with compatible DSC

wireless receivers: HSM2HOST9, HS2LCDRF(P)9, HS2ICNRF(P) 9, HS2LCDRFPRO9, PG9920, and

Qolsys IQPanel2, IQHub, IQPanel4. After installation, verify the product functionality in conjunction

with the compatible receiver used.

Safety Instructions

Read the safety information before you install the equipment.
The detector shall be installed and used within an environment that provides the pollution degree

max 2 and over voltages category II in non-hazardous locations, indoor only. The equipment is

designed to be installed by SERVICE PERSONS only; (SERVICE PERSON is defined as a person having

the appropriate technical training and experience necessary to be aware of hazards to which that

person may be exposed in performing a task and of measures to minimize the risks to that person

or other persons).
The PGP303 is powered by a CR2450 GP or Panasonic battery.

W.E.E.E Product recycling declaration

For information regarding the recycling of this product you must contact the

company from which you originally purchased it. If you are discarding this

product and not returning it for repair then you must ensure that it is returned

as identified by your supplier. This product is not to be thrown away with

everyday waste.

Directive 2012/19/EU Waste Electrical and Electronic Equipment.

About PGP303

The PGP303 is a thin, ultra-long-life PowerG magnetic contact device that is compatible with

Johnson Controls’ PowerG control panels.
The PGP303 includes a built-in reed switch that opens a circuit when the magnet is moved from its

usual position. The device has the following features:

Two-way PowerG communication with the control panel

Front and back cover tamper detection

LED light signal strength indication during installation

Discreet transmission of supervision message

PowerG two-way frequency hopping spread spectrum time-division multiple access (FHSS-

TDMA) technology

Low battery indication

Remote firmware upgrade

Limited Warranty

Digital Security Controls warrants that for a period of 12 months from the date of purchase, the

product shall be free of defects in materials and workmanship under normal use and that in

PGP303 Vanishing Door/Window Magnetic Contact Installation Guide

8

D-308443 PGP303 Rev. 0

Содержание PGP303













Отзывы: