Room Sensor Installation -
Page 2
Installation and Operation - Page 2
Repairs and Replacement
Do not make field repairs.
Please contact
Electronic Systems at (502) 495-6700 for
replacement and other services.
Electronic Systems USA 9410 Bunsen Parkway Louisville, KY 40220 (502) 495-6700
700
ESUSA reserves the right to update
specifications when appropriate. Informa-
tion contained in this document is based
on specifications believed to be correct at
the time of publication.
TEC DOC # LIT-TD-2034 11/00
MOUNTING
ECHELON
FTT-10A
50051
G9441B
ECHELON
FTT-10A
50051
G9441B
5.00ECSD
JP2
BUS
FREE
JP1
BUS
FREE
POWER
NET B
NET A
NET A -
NET A +
24VAC NEU
24VAC HOT
NET B -
NET B +
Electronic Systems USA
5.500
5.000
1.645
3.290
1.250
.125
All dimensions are shown in inches.
Figure 3 - Repeater dimensions
To mount the repeater:
1
. The repeater board comes factory installed
in the repeater box. See Figure 3 for
dimensions. Mount the box in an
appropriate place using the two mounting
holes.
2
. Remove the four screws holding the
repeater box cover. Remove the cover.
3.
Remove the terminal block from the
repeater board and attach the appropriate
network and power wires according to
Figure 2.
4
. Reinsert the terminal block.
5
. Verify that the jumpers are set correctly. The
factory setting is bus topology for both Net
A and Net B. See Figure 4.
6
. Reinstall the repeater box cover and its
four mounting screws.
Jumper Settings
(JP1/JP2)
Set for:
Free Topology Bus Topology
JP1
BUS
FREE
JP1
BUS
FREE
Figure 4. Jumper Settings for Network Topology.
Refer to the Network Wiring Guideline for
further details on wiring hardware on a L
ON
-
W
ORKS
®
network.
Copyright ©2000. Electronic Systems USA All Rights Reserved.
