D-308439 MP-802 PG+ Rev.0
Mounting the device using screws
Note:
Make sure to fasten the break-away segment to the frame. If the device is forcibly removed
from the wall, this segment will break away from the base, causing the tamper switch to open.
1.
To mount the device on a flat surface, screw the flat bracket to the wall. See the following
figure.
Figure 9: Flat bracket screw installation
2.
To mount the device on a corner surface, ensure the corner mounting insert is attached to
the back of the corner bracket. See B in the following figure.
Figure 10: Corner bracket screw installation
MP-802 PG+ Wireless PIR Motion Detector Installation Guide
11
