Johnson Controls JWS-3, Инструкция по установке и эксплуатации

Страница: 22 / 54

JWS-3 Embedded Installation Connecting an JWS-3 to a Network Control Module
22 JWS-3 Installation and Operation Manual - P/N: 53550:Rev: A1 1/12/10

NUP to NUP Cable Connection
Connect the cable between to the JWS-3 circuit board’s NUP connector and an HS-NCM-W/SF/
MF NUP connector.
Figure 2.10 NUP to NUP Connection
2.8 Connecting an JWS-3 to a Network Control Module
• Use an NCM-W for a twisted pair wire connection.
• Use an NCM-F for a fiber-optic cable connection.
 NUP to NUP Cable Connection
Connecting the JWS-3 to an NCM-W/F allows the gateway to communicate with devices on an
NFN network.
Figure 2.11 NUP to NUP Connection
Connect to an HS-NCM-W/SF/MF
NUP to NUP cable
PC Board
NUP A (J6)
USE NUP A ONLY
Connect to an NCM-W/F
NUP to NUP cable
NUP A (J6)
USE NUP A ONLY