Security
Installing the camera onto a wall or ceiling (continued)
15. Pass the insert tool and cable (1) (Figure 7) through the rubber
grommet hole (2) (Figure 7) on the camera lens module.
16. Remove the insert tool, connect the RJ 45 cable to the camera
lens module ethernet connector, and insert the rubber grommet
into the camera lens module hole to prevent water/dust ingress.
Figure 6
17. Snap the camera lens module into the mounting plate and secure
the two screws on the camera lens module into the two holes on
the mounting plate using the T20 Torx wrench.
18. Based on your needs, connect the power cable to the power port
through one of the following options.
•
POE 802.3bt Type 4 (90w) Class 8
(71.3W / 0.96A):
Connect
an Ethernet cable terminated with a RJ-45 connector to the PoE
RJ-45 port for both power supply and network connectivity
purposes simultaneously.
•
24V AC or DC (81W / 3.54A):
Connect a power cable that
supplies 24V or DC power source to the power terminal.
Installing the camera onto a wall or ceiling (continued)
OPTIONAL:
Insert audio in / out cables and alarm in / out cables to
the corresponding terminals on the camera if required and
plug in a
micro-USB device to the USB port.
Note:
The polarities should be matching when using 48V DC power
source. It is recommended to connect external microphones to
ground (GND) on the digital I/O connector.
Figure 7
19. Hold the camera top cover (1) (Figure 1) up to the camera lens
module and align the six holes on the camera top cover with the six
holes on the camera lens module.
20. Insert the six screws and securely attached the camera top cover
to the camera lens module.
© 2022 Johnson Controls. All rights reserved. JOHNSON CONTROLS,
TYCO and ILLUSTRA are trademarks and/or registered trademarks.
Unauthorized use is strictly prohibited.
