FX70 Supervisory Controller Installation Instructions
2
-
LP-FXPMUK-0 (90-240 VAC, with U.K. wall
adapter)
•
Communication cards (if ordered)
-
LP-FXLONFTT-1
-
LP-FXRS232-0
-
LP-FXRS485-0
-
LP-FXMDM-0
-
LP-FXWTC-0
-
LP-FXGPRS-0
-
LP-FXGPRSW-0
-
LP-FXSED-0
•
Expansion Input/Output (NDIO) Modules (if
ordered)
-
LP-FXRIO16-0
Materials and Special Tools Needed
The following supplies and tools are typically required
for installation:
•
LP-FXPM263-0 universal AC power supply
module, 90-263 VAC input, 15 VDC 30 W output,
DIN-mount capable, with grounding wire.
•
Alternatively, an LP-FXPMxx-0 wall-mount AC
adapter, which can power the controller only. You
must cut off the adapter’s barrel plug end, and then
wire leads into the controller’s end connector. A
multimeter is needed to check polarity.
•
DIN rail, type NS35/7.5 (35 mm x 7.5 mm) and DIN
rail end-clips (stop clips), unless using panel
mounting method with screws through mounting
tabs.
•
Suitable tools and fasteners for mounting unit and
accessories.
•
#2 Phillips screwdriver: used to install and remove
an optional option card.
•
Small flat-blade screwdriver: used for making
wiring connections to removable screw terminal
plugs.
•
(Optional) One or two 12 V Sealed Lead-Acid
(SLA) rechargeable backup batteries, with wire
harness for connecting to the 2-position connector
on the unit. Should be sized as required by the
system. See
Safety Precautions
Static Discharge Precautions
Static charges produce voltages high enough to
damage electronic components. The microprocessors
and associated circuitry within the FX70 are sensitive
to static discharge.
!
WARNING: Risk of Electric Shock.
Disconnect the power supply before
making electrical connections. Contact
with components carrying hazardous
voltage can cause electric shock and
may result in severe personal injury or
death.
AVERTISSEMENT: Risque de
décharge électrique.
Débrancher
l'alimentation avant de réaliser tout
branchement électrique. Tout contact
avec des composants conducteurs de
tensions dangereuses risque d'entraîner
une décharge électrique et de provoquer
des blessures graves, voire mortelles.
IMPORTANT:
Use copper conductors only. Make
all wiring in accordance with local, national, and
regional regulations. Do not exceed the FX70
Supervisory Controller’s electrical ratings.
IMPORTANT:
To reduce the risk of fire or electrical
shock, install in a controlled environment relatively
free of contaminants.
IMPORTANT:
Use this FX70 Supervisory
Controller only as an operating control. Where
failure or malfunction of the FX70 could lead to
personal injury or property damage to the controlled
equipment or other property, additional precautions
must be designed into the control system.
Incorporate and maintain other devices, such as
supervisory or alarm systems or safety or limit
controls, intended to warn of or protect against
failure or malfunction of the FX70.
IMPORTANT:
Work in a static-free area. Discharge
any static electricity you may have accumulated.
Discharge static electricity by touching a known,
securely grounded object. Do not handle the Printed
Circuit Board (PCB) without proper protection
against static discharge. Use a wrist strap when
handling PCBs. Secure the wrist strap clamp to
earth ground.
