Johnson Controls FX70, Руководство по установке

Страница: 8 / 21

FX70 Supervisory Controller Installation Instructions 8
To accept either, both option slots on the controller’s
base board have a 40-pin connector. See Figure 6.
Installing an option card is recommended before
mounting the unit. See
Installing an Option Card on
page 9.
Option cards typically provide additional
communications features, with the following available
models (with others still in development) listed in
Table 1.
!
WARNING: Risk of Electric Shock.
Disconnect the power supply before
making electrical connections. Contact
with components carrying hazardous
voltage can cause electric shock and
may result in severe personal injury or
death.
AVERTISSEMENT: Risque de
décharge électrique.
Débrancher
l'alimentation avant de réaliser tout
branchement électrique. Tout contact
avec des composants conducteurs de
tensions dangereuses risque d'entraîner
une décharge électrique et de provoquer
des blessures graves, voire mortelles.
IMPORTANT: Power to the controller must be OFF
when installing or removing option cards, or damage
occurs. Also, you must be very careful to plug an
option card into its connector properly (pins aligned).
Table 1: FX70 Supervisory Controller Option Cards
Order Codes Description Number of Option Cards Allowed per Controller
LP-FXRS485-0 Dual, optically isolated, RS-485 adapter
with two 3-position removable
screw-terminal connector plugs. One or two
LP-FXLONFTT-1 FTT-10A L
ON
W
ORKS
adapter with a
2-position removable screw-terminal
connector plug.
One or two
LP-FXRS232-0 Single port RS-232 adapter, with a
DB-9M connector. Supports baud rates
up to 115,200. One or two
LP-FXGPRSW-0 GSM cellular modem card using General
Packet Radio Service (GPRS), with
onboard socket for SIM card, and a
Wyless SIM. Includes a stub SMA
antenna. One
LP-FXGPRS-0 GPRS Modem card One
LP-FXWTC-0 Wireless TEC Option Card includes
option card, mounting bracket, and
direct-mount antenna. One
LP-FXSED-0 Sedona Framework™ option card with
both wireless IPv6 over LoW Power
Wireless Area Networks (6LoWPAN)
and wired RS-485 port, based on the
Jennic JN5139 wireless microcontroller.
Includes stub antenna. One
LP-FXMDM-0
56 Kbps Auto-dial/Auto-answer Modem
1
with one RJ-11 connector for phone line.
One
1
LP-FXSRAM-0 Static RAM option card: provides
battery-less backup One
1. Unlike with an FX22/FX62 with a LP-FXMDM-0 installed in slot 1, the onboard RS-232 COM1 port (DB9) remains
operational. Also, any LP-FXMDM-0 option is unaffected by the mode jumper position for serial shell access (jumper in
serial shell position affects the operation of the onboard RS-232 COM1 port only).