Johnson Controls DWCR2, Руководство пользователя, Страница: 41 / 44

Wired Controller
DWCR2
37
this wire through the “ ” hole at the
bottom
side of the
base
of
the
wired controller;
(3).
Screw
the
base
of
the
wired controller on
to
the wall and then use screw
M4×25 to
attach the base
and
back plate
on
the
wall together
.
(4).
Connect two-
conductor
twisted pair wire to H1 and H2
terminals
and then
tighten
the screws (
observe
polarity);
(5).
Block the
18AWG
two-
conductor
wire into the groove
on
the left side of
the
wiring column
. B
undle the front panel of wired controller to its
base
.
Note: If the procedures in point 2 and point 5 mentioned above
are
hard
to do because
the diameter of
the
selected communication wire is
too thick
, peel off the sheathed layer
to the
appropriate length.
4.4 Disassembly
Fig. 24 Disassembly diagram for wired controller