Connecting Serial Controllers to the P2000 Comark Server Running Software Version 3.11
Preliminary – This information may change.
5
The converter can function in any position, but we recommend mounting it flat against a wall
with the hinge to the right.
To be UL-compliant, the Current Loop Converter must be located in the same room and
within 20 feet (6.1 m) of the Proprietary Station.
Installing the Enclosure
To meet UL requirements, the PC232-S4-X board must be installed in the enclosure supplied
for the PC232-S4-X. This enclosure has four corner holes for mounting (see Figure 3). The
diameter of these holes is 0.196 inches (4.98 mm).
The enclosure has knockout holes for cable entry. You can bring cables to the mounting
location and terminate them before or after the enclosure installation, as dictated by the
requirements of the installation.
To install the enclosure:
1.
Remove the PC232-S4-X board from the enclosure by disconnecting the power cable
from J6 and the tamper switch cable from J1. Then, remove the four screws securing the
PC232-S4-X board to the enclosure.
2.
Set aside the screws in a safe place, so you can use them to replace the board into the
enclosure.
3.
Hold the enclosure in the desired location on the mounting surface and use as a template
to mark the location of the four mounting holes that correspond to the holes shown in
4.
Bore holes in the mounting surface at the four marks. If necessary, install hollow-wall
anchors.
5.
Mount the enclosure on the wall using appropriate hardware.
6.
Bring the cables to the mounting location, allowing enough excess cable for a service
loop.
7.
Determine the point of entry for each cable and remove the appropriate knockout(s).
8.
When using conduit, attach appropriate conduit fasteners to the conduit in the enclosure.
9.
Install the PC232-S4-X board removed in Step 1.
10.
Reconnect the power cable to J6 and the tamper switch cable to J1. You have completed
the enclosure installation.
