Johnson Controls CSIRK01, Руководство по установке, Страница: 7 / 12

6
Lead the connecting cable into the electrical box with other wires.
Attach the accessory insulation to the edge of the side cover (R) in order to prevent scratches by
contacting the connecting cable to the edge of the side cover (R).
7
Remove the electrical box cover. Connect the connecting cable to the terminals A and B at the terminal
block for the controller as shown in the figure. (There is no polarity between terminals A and B.)
5
Attach the IR receiver kit to the lower cover.
(1) Insert the IR receiver kit and the connecting cable in
the position for the IR receiver kit.
(2) Lead the connecting cable through the opening for the
connecting cable.
(3) Catch the three hooks of the IR receiver kit onto the
square holes.
Pay attention to the direction of the IR receiver kit
when it is attached.
NOTE:
Check whether the IR receiver
kit is securely attached.
Hook
IR Receiver Kit
Hooks
Service Opening
Opening for
Connecting Cable
IR Receiver Kit
Attaching Direction
for IR Receiver Kit
EMERGENCY
COOL HEAT
RUN FILTER DEF TIMER
Side Cover R
Flange
Insulation
Put the side cover R and the flange
at lower cover between insulations.
Connecting Cable for IR Receiver Kit
Side Cover R
Lower Cover
Lower Cover
Electrical Box
Terminal Block
for Controller
Connecting Cable for IR Receiver Kit
Printed Circuit Board (PCB1)
Mark Band “A”
Mark Band “B”
7