Johnson Controls Bentel Security tyco ABS128M50, Руководство по установке

Страница: 47 / 132

Device ID In the
Device ID
option, enter the ID number
that you find on the wireless device: if a valid ID number
is entered, the console shows the corresponding type of
wireless device, and the options that you can set for that
type of device. Set the wireless device options as indi-
cated in “Wireless device options” on page 128.
Enter all zeros to remove a wireless device.
Valid Values: three digits for the device type, and four
digits for the serial number.
Default: 000-0000.
Partitions Double click the plus [+] icon to expand the
view, and select the siren’s partitions. The siren repeats
the acoustic signals relating to the selected partitions:
entry delay, exit delay, squawk, etc.
Default: the siren is enabled on partition 1.
Alarm Masks Select the sounds that the siren can
emit:
Ø
Burglary Alarm
: continuous sound
Ø
Fire Alarm
: three half-second sounds every 1.5 sec-
onds
Ø
Gas/CO Alarm
: four short sounds (0.1 seconds) ev-
ery ten seconds
Ø
Flood Alarm
: a sound of one second every three sec-
onds
Default:
Burglary Alarm
,
Fire Alarm
,
Gas/CO Alarm
,
and
Flood Alarm
.
In the
Outputs
options group, each sound of the wire-
less sirens can be associated with a logical output
(mapping of the outputs).
The control panel is able to detect and signal the follow-
ing events relating to wireless sirens:
Ø
Low batter: when the siren battery needs to be re-
placed;
Ø
Device lost: when the supervision time has expired
since the last siren communication;
Ø
Tamper
n
Wireless Repeaters
The
Wireless Repeaters
option group is for repeater en-
rolling, as described below.
# In the column #, choose a free position to enroll the
wireless device.
Device ID In the
Device ID
option, enter the ID number
that you find on the wireless device.
Enter all zeros to remove a wireless device.
Valid Values: three digits for the device type, and four
digits for the serial number.
Default: 000-0000.
ABSOLUTA Plus PROGRAMMING FROM THE PC 47
Logger
Description WHO Events and Actions
WLS rec. lost N/A System > WLS receiver lost
WLS rec. tamper N/A System > Wireless Receiver Tamper
WLS rec. tamper N/A System > Wireless Receiver Tamper
WLS Det. Fault Zone Label System > System Fault
WLS rep. bat.low Device ID System > System Fault
WLS rep. AC trbl Device ID System > System Fault
WLS Rep. Fault Device ID System > System Fault
WLS rep. tamper Device ID System > General System Tamper
WLS rep. lost Device ID System > General System Tamper
WLS sir. bat.low Siren Label System > System Fault
WLS Sir. Fault Siren Label System > System Fault
WLS siren tamper Siren Label System > General System Tamper
WLS siren lost Siren Label System > General System Tamper
WLS Key Fault Keyfob Label System > System Fault
... the keypad, in viewing signals mode, shows the message indicated in the Message column; the logger shows the
description indicated in the Description column, and detail of the device that caused the event, as indicated in the
WHO column. N/A = Not Applicable.