13.
ERROR CODES
13.1 FLAME LOCKOUT
Should the heater fail to light after 5 attempts, it will lock out Error 1. Check
the gas meter is turned on and any pre-payment meters have credit.
Pressing the reset button will enable the heater to relight.
13.2 FLAME LOSE
Should the flame signal be lost 5 times in any 4 minute period then the
heater will lockout and an error code 26 will be displayed in the centre of
the display. Pressing the reset will enable the heater to relight.
If the fault recurs, turn off the heater and consult a GAS SAFE registered
installer.
13.3
For any error codes that you may encounter on your heater, please refer to your Installation &
Maintenance Instructions or contact your local Gas Safe registered installer.
14. CLEANING
14.1
If necessary, the heater cabinet may be cleaned using a mild soap solution. DO NOT use abrasive
pads or scourers.
15. IMPORTANT INFORMATION
FOR YOUR HEATER TO WORK EFFICIENTLY AND FOR YOUR HEATING SYSTEM
TO PERFORM SATISFACTORILY, IT IS ABSOLUTELY ESSENTIAL TO OBSERVE
THE FOLLOWING:
1.
DO KEEP CLEAN, and make sure you DO NOT OBSTRUCT any grilles on the heater, in the
heater compartment, or in any walls, windows or doors of the building.
2.
DO CLEAN AND REFIT the air filter at least once per month.
3.
DO NOT PLACE ANYTHING (clothing, linen etc.) in contact with the air heater or its flue pipe.
4.
DO NOT USE the heater compartment for storage or airing.
5.
DO NOT turn off the mains electricity supply to the air heater until the gas supply has been turned
off.
NOTE:
IF YOU ARE AWARE OF, OR SUSPECT, A FAULT OF ANY KIND THE HEATER MUST NOT BE
USED. TURN OFF THE GAS AND ELECTRICAL SUPPLIES TO THE HEATER AND CONTACT
YOUR SERVICE ENGINEER.
7
Sales/Spares & Replacement Help Line 01604 762881
e
