Copyright © 2022 Johnny’s Selected Seeds. All rights reserved.
1
SEED BREEDERS, GROWERS, AND MERCHANTS SINCE 1973
955 Benton Ave., Winslow, ME 04901
•
Phone: 1-877-564-6697
•
Fax: 1-800-738-6314
Email: [email protected]
•
Web Site: Johnnyseeds.com
Materials Included
•
(1) Connecta
TM
Receiver
•
(1) Oiled ashwood handle
•
(1) #6 x ¾" Rounded-head stainless steel wood screw
Additional Tools Needed
•
#1 Phillips screwdriver
•
3
/
32
" Allen wrench
ASSEMBLY INSTRUCTIONS
The Connecta
TM
Receiver comes fully assembled and only requires the oiled ashwood handle to be attached
before use.
1. Insert the tapered handle into the metal receiver as far as it will go, until it is secure in place.
Note:
Do not push the receiver down too far onto the handle as it could cause unnecessary strain on the
screws.
2. Secure the wooden handle into the metal receiver by inserting the #6 x ¾" wood screw provided into the
screw hole and tightening it with a #1 Phillips screwdriver.
OPERATION & USE
•
To attach a tool head into the receiver, press the button and insert the tool head shank until it clicks
securely into place. You will need to gently push it in so the rubber gasket depresses to form a tight fit.
Note:
Be sure the thumb grip on the tool head is in line with the receiver’s button.
•
To remove a tool head, press the button and slide the tool head out of the ferrule.
•
Extra tool heads for the Connecta
TM
Tool System can be stored on the
belt loop clip, allowing you to swap tool heads quickly and easily in the
field.
•
Important Note:
The Connecta
TM
Tool System is designed with tight
tolerances to keep the heads from shifting while in use. You may need
to insert new heads a few times before they fit snugly in the receiver.
Connecta
TM
Tool System
Assembly, Use & Maintenance
Tool shank
Thumb grip
Button
Receiver
Belt loop clip
Tool shank
