IL4291
Thank you for purchasing this Tilt Marble LED floor lamp. Please read the instructions
carefully before use to ensure safe and satisfactory operations of this product.
Please keep this instruction for future reference.
Warnings!
The supply cable runs through the inside of this product. Take care not to place
undue stress on the cable whilst unpacking to prevent the possibility of a poor
connection.
If you are in any doubt consult a person competent to give advice on the
assembly of electrical equipment.
If the external flexible cable of the lamp is damaged it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualified person in
order to avoid a hazard.
To prevent electrocution switch off at the mains supply before assembling or
maintaining this fitting. Ensure the plug is not connected to any power supply and
read instructions before assembly.
Caution! The bulb and surrounding parts can become hot during use.
For indoor use only.
The light source of this luminaire is not replaceable; when the light source
reaches the end of its end of life the whole luminaire shall be replaced.
For indoor use only.
Care instructions
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as
these will damage the finish.
Parts list
Part List
Qty
Part List
Qty
A
1
B
1
Assembly
Never assembly your appliance on a wet, freshly painted surface. Ensure to off at
the mains supply before assembling or maintaining this fitting.
Step 1
Unpack the product and remove all packaging. Be careful
not to scratch the surface of the product whilst removing the
wrapping.
Lay the product out on the floor. If the floor is not carpeted
please cover it with a soft cloth to avoid damage to the
flooring and surface of the product. Assembly should take
place with the product lying flat.
Rotate the centre pole onto the lamp holder/head section
ensuring that the lamp holder section is kept still and that the
pole is threaded on ensuring that the cable does not twist.
Step 2
Rotate the lower pole onto the centre pole section ensuring
that the centre pole is kept still and that the pole is threaded
on ensuring that the cable does not twist.
Step 3
Rotate the base section onto the pole assembly. Keep the
poles parallel to avoid cross threading. Keep the upper
poles stationary and only rotate the base section. Stand
the floor lamp upright and ensure all the assembled parts
are fully tightened.
Floor lamp is now ready for use.
Step 1
Step 2
Step 3
