01
02
Parts list
Introduction
Thank you for purchasing this Lexi Pendant.
Please read the instructions carefully before
use to ensure safe and satisfactory operation
of this product.
Warnings
This is a Class 1 product and must be earthed.
It is recommended that this fitting is installed by a qualified electrician.
Install in accordance with the IEE Wiring regulations and the Building Regulations.
To prevent electrocution switch off at mains supply before installing or maintaining
this fitting. Ensure other persons cannot restore the electrical supply without your
knowledge.
If you are in any doubt, please consult a qualified electrician.
This light fitting should be connected to a 5 amp fused circuit.
If replacing an existing fitting, make a note of the connections.
Always use the correct type and wattage bulb. Never exceed the wattage stated.
When changing a bulb or adjusting the heads, always switch off at the mains and
allow to cool down. Dispose of used bulbs carefully.
This product is suitable for indoor use only.
This product is suitable for installation on surfaces with normal flammability e.g.
wood, plasterboard, masonry. It is not suitable for use on highly flammable surfaces
(e.g. polystyrene, textiles).
For your safety, always switch off the supply before changing lightbulbs, cleaning
or removing shades. This product is made from glass and is heavy. Therefore take
extreme care when installing and cleaning this product, or changing the bulb, to avoid
damage or injury.
Recommended bulb (not included)
1 x 40W (Max.) ES GLS
or
1 x 28W ES ECO Halogen Classic
or
1 x 7W ES LED Energy Efficient Classic Clear
When changing a bulb, always switch off at the mains and allow the bulb to cool
before handling. Dispose of used bulbs carefully. Do not exceed the rated power
stated or use a different shape bulb from that indicated on the fitting.
Recommended Bulb
Product assembly
1
2
4
3
Height Adjustment
The drop of this product can be reduced. This is easier
to do before attaching the product to the ceiling. The
top chain link is a carabiner type link. Unscrew the
collar (C) on the link and detach the link from the
ceiling cover and chain. Work out the chain link that
the carabiner will attach to and refit the carabiner link to
this chain link and the hanging loop on the ceiling cover.
Tighten the screw collar on the carabiner. Remove the
excess chain links with a pair of pliers. Always ensure the
weight of the fitting is supported by the chain and not
the cable.
Remove the fixing bracket (A) from the ceiling cover
and attach to the ceiling using the screws (B) provided.
Ensure there is a joist at the point of fixing to support
the weight of the product. Take care to avoid damaging
any concealed wiring and pipes.
Check that:
You have correctly identified the house wires.
The connections are tight.
No loose strands have been left out of the connection
block.
When completed, ensure that there are no bare or
loose strands of wire exposed.
C
Refer to assembly diagrams below. Carefully unpack
the carton, making sure all the parts are present before
assembly.
Before removing the existing fitting, carefully note the
position of each set of wires.
2
2
Wall plugs
Screws
Light Fitting
1
NEUTRAL
EART H
SWITCHED LIVE
BLUE (N)
GREEN/YELLO W or
METALLIC EART H CONNECTION
BROW N (L)
HOUSEHOLD SUPPL Y
LIGHT FITTING
5
Re-attach the product to the fixing bracket and tighten
the side screws.
Take care not to trap any wiring.
Fit a recommended bulb into the product.
Replace fuse or circuit breaker and switch on. Your light
is now ready for use.
A
