John Lewis jlffw2018, Руководство пользователя

Страница: 18 / 28

GREEN & YELLOW
13 AMP. FUSE
BROWN
CORD CLAMP
BLUE
Important! The wires in the mains lead
are coloured in accordance with the
following code:
1
Green and Yellow: Earth
3
Brown: Live
5
Blue: Neutral
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either with
the letter “E“ or by the earth symbol or
coloured green and yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter
“N“ or coloured black.
3. Connect the wire coloured brown to the
terminal either marked with the “L“ or
coloured red.
4. Check that no cut, or stray strands of wire
is present and the cord clamp
4
is secure
over the outer sheath.
5. Make sure the electricity supply voltage is
the same as that indicated on the appliance
rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug
fitted
2
. In the event of having to change the
fuse in the plug supplied, a 13 amp ASTA
approved (BS 1362) fuse must be used.
Warning! A cut off plug inserted
into a 13 amp socket is a serious
safety (shock) hazard. Ensure
that it is disposed of safely.
Permanent connection
In the case of permanent connection it is
necessary that you install a double pole switch
between the appliance and the electricity supply
(mains), with a minimum gap of 3mm between
the switch contacts and of a type suitable for the
required load in compliance with the current
electrical regulations.
The switch must not break the green and yellow
earth cable at any point.
Rear spacers
2
4
3
1
You can find the two spacers in the bag with
documentation.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
18 Fridge-Freezer user manual