16
Maintenance and Cleaning
Defrosting
Freezer
The freezer is Frost Free, defrosting is completly automatic.
The defrosted water will flow down a tube located at the
back of the appliance to a reservoir located over the
compressor (Motor). The heat from the compressor will
cause the water in the reservior to evaporate.
Refrigerator
The defrosting system in the refrigerator is "automatic
defrost" The refrigerator will defrost without any
intervention from the user.
The thermostat will interrupt the cooling cycle at regular
intervals and the temperature of the cooling surfaces will
increase to above 0'c and any ice crystals will defrost. Once
the temperature of the cooling surfaces reach +3' to +4'c
the thermostat control restarts the cooling cycle.The length
of the defrosting cycle will depend on the temperature in
side the refrigerator, the quantity of food stored and the
rooms ambient temperature.
The defrosted water will flow down to a channel located at
the bottom of the inside back wall and flow through an
outlet to a reservoir located over the compressor (Motor).
The heat from the compressor will cause the water in the
reservoir to evaporate.
Check the outlet on a regular basis to ensure
it is clean and no foods or objects are
obstructing the flow of water. If the outlet is blocked,
water will gather at the bottom of the refrigerator.
If the defrosted water seeps into the insulation of
the refrigerator this could cause failure of the
insulation.
Clean the water outlet with the pipe cleaner
supplied and stored in the outlet.
Regular cleaning
Disconnect the appliance from the electricity supply,
before you carry out any cleaning or maintenance work.
Clean the equipment regularly.
Don't use detergents, abrasive or strongly
odorous cleaners, waxy polishing agents,
disinfectants or alcoholic products for cleaning
the equipment.
Pull out the wall plug of the equipment from the outlet.
Internal cleaning
Clean the internal parts of the equipment and the
accessories with warm water and Bicarbonate of Soda (5
ml to 0.5 litre of water).
Rinse and dry everything thoroughly.
Clean the door seal profile with clean water.
External cleaning
Clean the external parts of the equipment with warm
water and Bicarbonate of Soda (5 ml to 0.5 litre of
water).
Dust will build up on the condenser (the black grill at the
back of the appliance) and the reservoir; this can inhibit
the efficiency of the fridge freezer. It is recommended to
clean both on a six monthly basis.
After cleaning, reconnect the equipment to the mains
supply.
When the refrigerator is not
in use
If the refrigerator is to be turned off for some time,
follow these steps.
Unplug the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Defrost and clean as detailed above.
Trouble shooting
Changing the Light Bulb
Should the light fail to work you can change it as below:
Disconnect the appliance from the electricity supply.
Press the rear hook (1) and at the same time slide the
cover in the direction indicated by the arrow (2). So the
bulb can be replaced. (Bulb type:T 25 230-240 V, 25 W,
E 14 thread)
After changing the bulb replace the cover, snap it in place
and plug the appliance back into the mains supply.
Clean the melting water outlet with the supplied pipe
scraper that can be seen in the figure.The pipe scraper has
to be stored in the outlet.
The most typical case of clogging up in the melting water
outlet when you put food wrapped in some paper into the
appliance and this paper contacts back plate of the
refrigerator and freezes to it. If you remove the food right
at this moment the paper will tear and it can cause clogging
up in the outlet by getting into it.
So you are asked to be careful - because of the above - when
placing foods wrapped in paper into the appliance.
It is possible during a heatwave that compressor will
operate continuously; during this time the defrosting
cycle will not work.
Ice will be seen to a greater degree on the back wall.
Once the heatwave has passed the refrigerator will
return to normal operations.
You must disconnect the appliance from the
electricity supply, before you can carry out any
cleaning or maintenance work.
