Troubleshooting
If the appliance does not start or it stops during
operation. Before you contact an Authorised
Service Centre, check if you can solve the
problem by yourself with the help of the
information in the table.
Warning! Repairs not
properly done may result in
serious risk to the safety of
the user. Any repairs must be
performed by qualified
personnel.
With some problems, the display shows
an alarm code.
The majority of problems that can occur
can be solved without the need to
contact an Authorised Service Centre.
Problem and alarm code
Possible cause and solution
You cannot activate the appliance.
• Make sure that the mains plug is connected to the mains socket.
• Make sure that there is no damaged fuse in the fuse box.
The programme does not start.
• Make sure that the appliance door is closed.
• Press
Start
.
• If the delay start is set, cancel the setting or wait for the end of the
countdown.
• The appliance has started the procedure to recharge the resin inside
the water softener. The duration of the procedure is approximately 5
minutes.
The appliance does not fill with wa-
ter.
The display shows
or
.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too low. For
this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
The appliance does not drain the
water.
The display shows
.
• Make sure that the sink spigot is not clogged.
• Make sure that the filter in the outlet hose is not clogged.
• Make sure that the interior filter system is not clogged.
• Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
The display shows
.
• Close the water tap and contact an Authorised Service Centre.
Dishwasher User Manual
27
