John Lewis JLBIOS632, Руководство пользователя

Страница: 32 / 48

1. Clean the oven floor with warm water and
washing up liquid, then dry it.
2. Set the function .
3. Set the oven temperature to 250 °C and let
the oven operate for 1 hour.
4. When the oven is cool, clean it with a soft and
wet sponge.
Removing and installing the
door
You can remove the door and the internal glass
panels to clean it. The number of glass panels is
different for different models.
Warning! Be careful when you
remove the door from the
appliance. The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on the two
door hinges.
A
A
3. Close the oven door to the first opening
position (approximately 70° angle).
4. Hold the door with one hand on each side and
pull it away from the appliance at an upwards
angle.
5. Put the door with the outer side down on a
soft cloth on a stable surface. This is to prevent
scratches.
6. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
1
2
B
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top edge
one by one and pull them up out of the guide.
9. Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is completed, do the above
steps in the opposite sequence. Install the
smaller panel first, then the larger and the door.
Warning! Make sure that the
glasses are inserted in the
correct position otherwise the
surface of the door may
overheat.
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
Warning! Danger of
electrocution! Disconnect the
fuse before you replace the
lamp.
The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
Oven User Manual 32