John Lewis JLBILIC07, Руководство пользователя

Страница: 15 / 28

Problem Possible cause Solution
Water flows on the
ground. The melting water outlet does not
flow in the evaporative tray above
the compressor. Attach the melting water outlet to the
evaporative tray.
The temperature in the
appliance is too low. The temperature regulator is not set
correctly. Set a higher temperature.
The temperature in the
appliance is too high.
The temperature regulator is not set
correctly. Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high. Let the product temperature
decrease to room temperature
before storage.
Many products are stored at the
same time. Store less products at the same time.
There is no cold air circulation in the
appliance. Make sure that there is cold air
circulation in the appliance.
Upper or lower square is
shown in the temperature
display. An error has occurred in measuring
the temperature Call your service representative (the
cooling system will continue to keep
food products cold, but temperature
adjustment will not be possible).
dEMo appears on the
Display.
The appliance is in demonstration
mode (dEMo) Keep pressed approximately 10 sec.
the OK button since a long sound of
buzzer is heard and the Display shut
off for a short while: appliance start
works regularly.
Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Service Center .
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Force Centre.
user manual 15