John Lewis JLBIGH602, Инструкция по эксплуатации

Страница: 15 / 24

15
3
Dimensions are given in mm.
Building over a kitchen Building over a kitchen
Building over a kitchen Building over a kitchen Building over a kitchen
unit with door
unit with door
unit with door unit with door unit with door
Proper arrangements must be taken in
designing the furniture unit, in order to avoid
any contact with the bottom of the hob which
can be heated when it is operated. The
recommended solution is shown in diagram
3.
The panel fitted under the hob ("a") should
be easily removable to allow easy access if
technical assistance is needed. The space
behind the kitchen unit ("b") can be used for
connections.
Fitting the Hob into the Fitting the Hob into the Fitting the Hob into the Fitting the Hob into the Fitting the Hob into the
W
W W W Worktop orktop orktop orktop orktop
Carry out the building in of the hob as
follows:
1. place the seals supplied with the hob
on the front edge of the cut out. Then,
place them at 11 mm from the side
edges and at 10 mm from the rear
edge, as shown in the diagram, taking
care that the seals meet without
overlapping.
2. Place the hob in the cut out, taking
care that it is centred.
3. Fix the hob with the relevant fixing
clamps, supplied with the injectors kit
(see diagram). When the screws have
been tightened, the excess seal can be
removed.
The edge of the hob forms a double seal which
prevents the ingress of liquids.
Seal Seal
Seal Seal
Seal