John Lewis JLBIDW917, Руководство пользователя

Страница: 33 / 40

Water connection
Water inlet connection
This appliance may be fed with either hot
(maximum 60 °C) or cold water. Nevertheless
we advise you use a cold water supply. A hot
water supply is not always efficient with heavily
soiled crockery as it shortens the washing
programmes a lot. For making the connection
itself, the coupling nut fitted to the appliance
inlet hose is designed to screw onto a 3/4" gas
thread spout or to a purpose made quick-
coupling tap such as the Press-block. The water
pressure must be within the limits given in the
‘Technical data’. Your local Water Authority will
advise you on the average mains pressure in
your area. The water inlet hose must not be
kinked, crushed, or entangled when it is being
connected. The appliance features inlet and
drain hoses which can be turned either to the
left or the right to suit the installation by means
of the locknut. The locknut must be correctly
fitted to avoid water leaks. If the appliance is
connected to new pipes or pipes which have not
been used for a long time, you should run the
water for a few minutes before connecting the
inlet hose. This appliance has been fitted with
safety features which will prevent the water
used in the appliance from returning back into
the drinking water system. This appliance
complies with the applicable plumbing
regulations.
Caution! Do not use inlet and
drain hoses which have
previously been used on
another appliance.
Water drain connection
The end of the drain hose can be connected in
the following ways:
• To the sink outlet spigot, securing it to the
underside of the work surface. This will prevent
waste water from the sink running into the
appliance.
• To a stand pipe provided with venthole,
minimum internal diameter 4 cm.
max.
4000 mm
min. 400 mm
max. 850 mm
The drain hose can face either to the right or left
of the appliance. Ensure the drain hose is not
bent or squashed as this could prevent or slow
down the discharge of water. The sink plug must
not be in place when the appliance is draining as
this could cause the water to syphon back into
the appliance. If you use a drain hose extension,
the internal diameter must be no smaller than
the diameter of the hose provided. Likewise the
internal diameter of the couplings used for
connections to the waste outlet must be no
smaller than the diameter of the hose provided.
Our appliances are supplied with a security
device to protect against the return of dirty
water back into the appliance. If the spigot of
your sink has a "no return valve" incorporated
this can prevent the correct draining of your
appliance. We therefore advise you to remove
it. When connecting the drain hose to an under
sink trap spigot, the entire plastic membrane (A)
Dishwasher User Manual 33