John Lewis JLAFFB2011, Руководство пользователя

Страница: 21 / 32

Fridge freezer user guide 21
Installing the water filter
1 Remove the locking cap befgore installing the filter.
connect your fridge freezer to the water supply:
The water pipe / tube should only be connected to your cold
water supply.
1 Connect the water pipe / tube to the fridge freezer.
2 Connect the pipe / tube to the tap connector, place the
rubber washer inside the tap connector and screw onto
the water tap.
Notes:
The water pressure should be 1.96~8.62 Bar or more to run
the automatic icemaker. Checkup your tap water pressure; if a
cup of 180cc is full within 10 seconds, the pressure is OK.
When installing the water tubes, ensure they are not close to
any hot surfaces.
The water filter only filters water; it does not eliminate any
bacteria or microbes.
If your water pressure exceeds 8.62 bar a pressure reducing
valve must be installed.
Use sealing tape on each pipe / tube connection to ensure
there are no water leaks.
Installing the water line
You will require the following component (not supplied to
connect your fridge freezer to the water supply:
• Connector
• Water pipe / tube
Connector Water pipe / tube
(note: The ice and water dispenser can also be used without
water filter, in which case the locking cap must be used.)
2 Carefully push in the water filter and turn it clockwise.
Change the water filter every 6 months. Concact your local
John Lewis branch or our warranty administrator to buy a
new genuine water filter.