6
Instructions for use
Where to put your radio
It is important that you consider
carefully in advance where your radio
will be situated and make sure that
it is:
* on a flat and stable surface
Note:
Never place your radio
on antique or polished surfaces��
* within metres of a power
socket
* where you have good wireless
network reception
* where you can fully extend the
telescopic aerial
* away from bright sunlight or heat
sources, such as a radiator
* not in a humid or very damp
place such as a bathroom
Setting up
Before you can receive internet radio
stations you will need to check that
you have the following:
* A broadband internet connection
* A wireless access point (Wi-Fi)
connected to your broadband
internet, preferably via a router��
* If your wireless network
is configured to use Wired
Equivalent Privacy (WEP) or
Wi-Fi Protected Access (WPA)
data encryption then you will
need to know the WEP or WPA
code so that your radio can
communicate with your network��
* Depending on the security used
on your network you may need
to enter your Radio’s ‘MAC
address’ into your wireless
access point�� To find your Radio’s
MAC address, select ‘Menu ->
Main menu -> System settings
-> Network -> View settings ->
MAC address’��
* To enter the MAC address into
your wireless access point, you
will need to read the instructions
provided with your wireless
access point and router��
* Your radio should work in
all locations where the Wi-Fi
network is available�� You will also
need to know the name of your
wireless network, i��e�� its SSID��
* Before you continue please make
sure that your wireless access
point is turned on and connected
to your broadband internet��
You may need to read the
instructions provided with your
wireless access point and router��
Note:
If you have a wireless laptop
computer available you can use
this to check that the wireless
network is working OK before
you begin to set up your radio��
Remote control
Your remote control requires 1 x
CR05 battery (supplied)��
1.
On the back of the remote, pull
the plastic isolation tab to remove it
and activate the battery��
Your remote control is now ready
for use��
Note:
Only use the recommended
battery or those of the same
equivalent type��
Batteries are to be inserted with
the correct polarity��
•
•
Cyber Internet Radio.indd 6
1/9/11 17:20:47
