Step 1
Insert Dowel M10 x 50mm (S) and Barrel Nut M6 (B) into the Headboard Panel (1) and Headboard
Bottom Panel (2) as shown. Attach Headboard Panel (1) and Headboard Bottom Panel (2) to the Leg
Pole Left (3) and Leg Pole Right (4) using A Phillips Head Screwdriver and Allen Key M4 (A). Please
use a Phillips Head Screwdriver to align the Barrel Nut M6 (B) into the hole position to ensure Bolt
M6x 100mm (F) is fully secured. Then repeat to assemble the Headboard Panel (1) to both Leg
Poles (3) & (4) for other end.
Step 2
Insert Barrel Nut (B) into Side Rail Front (11), Side Rail Back (12) and Bottom Side Rail (13), using the
pre-drilled holes on both ends. Attach Side Rail Back (12) to the Headend and Footend. Then tighten it using
the Bolt M6 x 100mm (F) with Allen Key M4 (A). Repeat this for the Side Rail Front (11). Attach
Bottom Side Rail (13) to the headend and the footend and tighten it using Bolt M6 x 100mm (F) with Allen
Key M4 (A).
Please ensure that parts 11, 12 and 13 have been correctly positioned as shown in the above diagram. Part 11
must be correctly positioned to allow the ladders to be attached to the correct side of the high sleeper.
Please Note:
Only 1 headboard bottom
panel (2) is required.
