Page : 3
Step
1
Step 2
Fitting
Fitting
C x 8
D x 8
A x 4
B x 8
E x 8
F x
1
: Insert cross dowels (A) into the legs (
1)
by placing each fitting (A) into the hole on top of each
leg as shown. Ensure the horizontal marking on each fitting (A) is facing out as shown.
: Insert 2x threaded bolts (B) into the two holes on the bevel of each leg then tighten
them into the holes of fitting (A) that is concealed in each leg (
1)
as shown.
With the help of an assistant:
: Lay the table top (2) on a flat, stable, clean and soft surface. Attach each leg (
1)
into place by
inserting bolts (B) into the predrilled holes of each metal corner bracket as shown.
: Insert flat washer (C), lock washer (D) and hex nut (E) onto all threaded bolts (B) as shown
and in the order as shown - (C) followed by (D) followed by (E).
Tighten hex nut (E) on top then tighten the hex nut (E) on bottom using the spanner (F)
as shown. Continue to re-tighten all hex nuts until they are securely fastened.
1
1
2
2
C
D
Step By Step Assembly Instructions
1
1
Tighten first
IW-17-4335-012-0
